Colourless Oil Refurbisher 285 0.25 l
€14.65
Product information "Colourless Oil Refurbisher 285 0.25 l"
Application
For treating all oiled and waxed surfaces such as wood, cork and linoleum in indoor areas, to prevent the formation of worn paths.
Technical properties
Transparent, easy to use. The open-pored, silk-matt, hard-wearing and water-repellent surface is resistant to yellowing. Tested for migration in accordance with DIN EN 71, Part 3. Sweat and saliva resistant in accordance with DIN 53160.
Colour
002 Colourless
Ingredients
Linseed oil, wood oil, castor oil, natural resin esters, isoparaffins, zinc oxide, alumina, kaolin, talc, micro-wax, silica, drying agents.
Substrate and preparation
The substrate must be dry (wood moisture content max. 14 per cent) and free from dirt and grease. Clean using LEINOS Vegetable Soap 930 (wipe with a damp cloth). Rinse with clean water. Allow the floor to dry thoroughly. The floor temperature during application must be at least 16 °C.
How to apply
Stir thoroughly before use! Apply the Oil Refurbisher evenly and in a thin layer using a short-pile floor mop. After 15–20 minutes, remove any excess oil and polish the surface with a white pad. Heavily worn and faded, dry surfaces must be treated a second time with Oil Refurbisher. Heavily worn, stressed surfaces can also be treated with Hardwax Oil 290. Carry out a test application first! Ensure optimal fresh air circulation during application and drying!
Oil wash: Depending on the degree of soiling and the absorbency of the wood, apply 100–200 ml/m² evenly. Then use a green pad to loosen the dirt and carefully wipe it away with a rubber squeegee or similar tool. Depending on the level of soiling, this soiled solution can be reused approximately 2–3 times on the adjacent area. Once the floor area of a room has been cleaned, rub it down completely once more with a white pad until no residue remains. To achieve a uniform surface finish, after a drying time of approx. 24 hours, Oil Refurbisher can be applied very thinly, drop by drop, using a white polishing pad. Carry out a test application first!
Drying time
Dry after 6–12 hours (20 °C, relative humidity 50–55 per cent); ready for sanding and recoating. Floors can be used with care after 1 day. Full use after 7–14 days. This system requires atmospheric oxygen to dry. Therefore, ensure good ventilation; if the air is stagnant, use a fan, for example (also to prevent odours from developing).
Coverage
Consumption and coverage depend on the absorbency of the surface and the intended use. Maintenance: approx. 30–40 ml/m². Oil cleaning: approx. 100–200 ml/m². Determine the exact consumption on site.
Thinner and cleaning agent
Immediately after use, clean with LEINOS Thinner 200.
Storage and shelf life
Store in a cool, dry place, away from frost. Seal the container tightly. Unopened, it will keep for at least 2 years. Remove any skin that may have formed before using again.
Special notes
Store work materials impregnated with the product, where the oil has not fully dried, in an airtight metal container or in water, and then dispose of them, as there is otherwise a risk of spontaneous combustion due to the vegetable oil content. The natural raw materials used may cause a characteristic odour. When using spray equipment, wear approved respiratory protection. Wear a fine dust mask when sanding!
Colour specifications and colour swatches are for guidance only. Colour variations are possible depending on the batch, substrate and printing technique. The dried original colour tone differs from the fresh colour tone in the container. A test coat with colour matching is therefore essential. Mix different batches of the same colour together.
VOC content: 660 g/l. EU limit value: 700 g/l. (Cat. f). GISCODE: Ö 60+ / EAK: 08 01 11
Hazard statements
Contains: Hydrocarbons, C10-C13, n-alkanes, iso-alkanes, cyclic, < 2% aromatics. May be fatal if swallowed and enters airways. Harmful to aquatic life with long lasting effects. Repeated exposure may cause skin dryness or cracking. Safety data sheet available on request.
Safety instructions
Keep out of reach of children.
IF SWALLOWED: Call a POISON CENTER/doctor if you feel unwell.
Do NOT induce vomiting.
Avoid release to the environment.
Dispose of contents/container to an appropriate recycling or disposal facility.
Technical data sheet (PDF) · Safety data sheet (PDF, in German)
| Colour: | Colourless |
|---|---|
| Size: | 0.25 l |
Login